FLEXVOX 99X
C2TE Class High Performance and Stable Adhesive
- Packaging
- 25 kg kraft bag
- Application area
- Interior and exterior facades, wall, floor, wall
- Consumption
- 85-100 sqft / 6-8 m²
High performance, reduced slip property, suitable for underfloor heating, bathrooms, and wet areas with a long working time
cement-based adhesive mortar.
Surface Preparation
• The surface must be clean, dry, smooth, and solid; any plaster thinner than 3 mm on the surface must be completely removed.
• Porous surfaces should be moistened and allowed to remain damp until the water layer disappears.
- Complies with TS EN 12004 C2TE Class.
- C: Cement-Based 2: High Performance
- T: Reduced Slip Property
- E: Extended Working Time
• The mixture should be prepared with a low-speed mixer. No additives not mentioned in the application instructions should be used.
• The dusty surface behind the ceramic should be wiped with a clean cloth.
• The mortar should be mixed with a medium-speed mixer for 3 - 5 minutes until it reaches a ready state.
• The prepared mortar should rest for 5 - 10 minutes. It should be mixed again for 2 - 3 minutes before starting the application.
• To achieve better adhesion, the mortar should be prepared with the flat side of the selected trowel according to the surface, and then combed with the notched side of the trowel suitable for the tile size.
• Tiles applied with force on the combed mortar should be adhered within 30 minutes. Adhesion should not be performed on the mortar under unsuitable environmental conditions such as high temperature, low humidity, and wind; the mortar should be removed from the surface.
• Used for bonding floor and wall ceramics to concrete surfaces, plaster, screed, and wall surfaces horizontally and vertically.
• Used for bonding pool ceramics in indoor and outdoor environments.
• Suitable for wet areas such as pools, water tanks, baths, and bathrooms.
• Has high adhesion stability.
• Does not slip, easy to use.
• The surface should be primed with 133P Primer before ceramic bonding applications on existing ceramic surfaces.
6.5-7.5 liters of clean water is placed in a clean, round-shaped container, and 25 kg of powder product is slowly added while mixing until a homogeneous appearance is achieved without lumps. The mixture should be made with a low-speed mixer. Fresh mortar should be mixed again before application after resting for 5 minutes.
• Avoid application at temperatures below +5°C and above +35°C.
• Pay attention to the amount of water remaining in the mortar.
• Do not add powder and water to mortar that has exceeded its usage period.
• If there is crusting in the material, re-wetting is not recommended.
• It is recommended to use latex gloves during product application.
• The product should not be inhaled directly. A dust mask should be used if necessary.
• Products should be stored out of reach of children.
• Consult a doctor if necessary.
• R38 Irritates skin.
• R41 Risk of serious eye damage Contains Chromium VI. Allergic reactions may occur.
• R43 May cause sensitization by skin contact.
• Keep out of reach of children.
• S22 Do not breathe dust.
• S24/25 Avoid contact with eyes and skin.
• S26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
• S37/39 In case of ingestion, seek medical advice immediately, show the product container and label.
No technical documents have been uploaded for this product yet.