STOPVOX
Water Stop is a fast-setting sealing material that prevents water leaks.
- Packaging
- 5 kg bucket
- Application area
- Basements, retaining walls, voids in formwork reinforcement bars
Features
- Can be applied in powder and paste form.
- Easy to apply.
- Provides impermeability with rapid setting.
- Does not shrink or crack.
- Very high mechanical strength.
A sealing material that can be applied in powder and paste form, impermeable, rapid-setting, preventing active water leaks, containing mineral fillers and special cement.
Surface Preparation
- The surface must be cleaned of residues that may prevent adhesion.
- On hot surfaces, the surface should be cooled with water without delay.
- The surface must be cured and solid.
- Loose particles, soil, oil, paint, tar, and other residues that may prevent adhesion should be cleaned from the surface.
- Cracks and voids should be chiseled out to a width and depth of up to 2 cm, and loose particles should be cleaned.
Application
Paste Application
- Add 0.20-0.22 liters of clean water to 1 kg of powder and knead by hand to achieve a paste consistency.
- The paste should be applied within a maximum of 30 seconds once it starts to heat up.
- Pressure application should continue until the active water leak is prevented (approximately 10 seconds).
Powder Application
- A small amount of powder taken in the palm should be applied by hand, in a single motion and with pressure, to the area of the water leak.
- Pressure application should continue until the active water leak is prevented (approximately 10 seconds).
- Immediately after application, excess material on the surface should be removed with tools such as chisels or spatulas, and the surface should be smoothed.
- Used to stop and seal active water leaks in basements, retaining walls in foundations, concrete water tanks, and concrete pipes under pressure or in leakage.
- In waterproofing of pipe and cable penetrations.
- Used to fill and insulate voids in formwork reinforcement bars.
Mixing Ratio 0.20 LT WATER/1 KG POWDER
Powder Pot Life: 30 SECONDS
Final Cure: 2 MINUTES
Avoid application below +5°C and above +35°C.
- The surface to be applied must not be damp.
- After application, protect from direct sunlight, strong winds, high temperatures (+35°C and above), rain, and frost.
- It is recommended to use latex gloves during product application.
- The product should not be inhaled directly. A dust mask should be used if necessary.
- Products should be stored out of reach of children.
- Consult a doctor if necessary.
- R38 Irritates skin.
- R41 Risk of serious eye damage Contains Chromium VI. Allergic reactions may occur.
- R43 May cause sensitization by skin contact.
- Keep out of reach of children.
- S22 Do not breathe dust.
- S24/25 Avoid contact with eyes and skin.
- S26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
- S37/39 In case of ingestion, seek medical advice immediately, showing the product container and label.